10
Installation position of an M8 bolt
M8 (Screw pitch : 1.25 mm, effective depth : 24 mm)
Note : Unified inch screws cannot be used.
Speaker's
bottom surface
Changing the orientation of
the front panel logo
Turn the logo mark while holding its edges
to change its orientation.
10.1.3. HY-C0801 and HY-C0801W Ceiling Mount Brackets
[ For ceiling installation, horizontal angle adjustable ]
Installing the HS series speaker to a ceiling in
conjunction with the HY-1500 series Mounting Bracket
permits the speaker's horizontal angle to be adjusted.
The figure at right shows an example of vertical
speaker installation.
10.1.4. HY-W0801 and HY-W0801W Wall Mount Brackets
[For ceiling installation, horizontal angle adjustable]
Installing the HS series speaker to a ceiling in
conjunction with the HY-1500 series Mounting Bracket
permits the speaker's horizontal angle to be adjusted.
The figure at right shows an example of horizontal
speaker installation.
Ceiling mount
bracket
Mounting
Bracket
Mounting
Bracket
10.1.5. Safety wire installation [ For speaker fall prevention ]
When mounting the speaker system to the ceiling or wall, install a safety wire as needed.
When installing the safety wire, be sure to follow the instruction below.
Failure to do so may cause the speaker to fall, resulting in personal injury.
Use a wire rope of 2mm(0.08”) or more in diameter. (The safety wire is not supplied.)
Tighten the safety wire to take up the slack. Otherwise, impact shock at speaker fall may cause the
Wire connected parts or wire itself to break.
Install the safety wire to a place that can structurally support the full weight of load.
Screw a speaker suspension bolt (M8) into one of the screw holes on the speaker's bottom surface.
Then, connect the safety wire to the bolt.
WARNING
Wall mount
bracket
