Toa HNW-500, Руководство пользователя

Страница: 3 / 4

When connecting the dividing network to the woofers, use the low frequency output cord of the dividing
network.
When connecting the dividing network to the compression driver, use the supplied high frequency
connecting cord.
Connect each polarity as shown below :
1) Low frequency : Red of the output cord to
2) High frequency :
HNW-500
Black of the output cord to
HNW-800
Standard Speaker
System Model No.
GS-3806W
GS-386W
Output Terminal No.
1 2
Standard Speaker
System Model No.
GS-382S
GS-302W
GS-302S
Output Terminal No.
1
2
SYSTEM SELECTION
CONNECTION
Connect the system selection jumper according to the standard speaker system to be used as shown
below : The optimum crossover characterisics in each speaker system is obtainable.
HNW-500
HNW-800
Standard Speaker
System Model No.
Jumper Connection
GS-3806W
GS-386W
Standard Speaker
System Model No.
GS-382S
GS-302W
GS-302S
Jumper Connection
HIGH FREQUENCY LEVEL CONTROL
High frequency level can vary in conjunction with the jumpers for the high frequency level control as shown
below : Flat frequency response is obtainable when the high frequency level control is set to Normal.
Note : The Jumpers are factory-preset to +2 dB.
Select the appropriate level according to conditions at installation locations.
Jumper
Connection
High Frequency Level
+2 dB Normal - 2 dB
Consider standard values because dB value is changed according to the frequencies.
When piling up the unused jumpers at the same terminal where installed the jumper to be used, they can
be utilized for future change of the speaker system or level change.
- 3 -