URL: http://www.toa.jp/
133-01-00024-00
6. ABOUT THE COMBINATION WITH OPTIONAL EqUIPMENT
6.1. Attaching an Optional Front Grille FG-C0651
Squeeze the two springs of the front grille and mount them to their corresponding spring catch holders located on the side
of the speaker.
Note : For specifications of the front grille FG-C0651, refer to the instruction manual attached to the front grille.
6.2. Installing an Optional Matching Transformer MT-S0601
To install the MT-S0601 transformer in the speaker system,
remove the blank panel located at the side of the speaker. For
the installation method, refer to the instruction manual attached
to the MT-S0601 transformer.
6.3. Low Frequency Equalization By Digital Signal Processors
Low frequency characteristics can be corrected using TOA’s
digital signal processor. When using the speaker in combination
with the digital signal processor, the settings shown in the table
at right are recommended.
The speaker complete with a front
grille attached by means of a spring.
MT-S0601
Primary terminal
High impedance
100 V line
High impedance
70 V line
83Ω
-
60 W
170Ω
60 W
30 W
330Ω
30 W
15 W
670Ω
15 W
7.5 W
TYPE
Freq.
Gain
Q
HPF
40 Hz
-
Q 0.500
PEQ
90 Hz
+10 dB
Q 2.456
PEQ
180 Hz
-4 dB
Q 1.414
PEQ
630 Hz
+3 dB
Q 1.850
7. SPECIFICATIONS
Enclosure Type
Sealed type
Power Handling Capacity
180 W (continuous program)
60 W (continuous pink noise)
Nominal Impedance
8 Ω
Output Sound Pressure Level
96 dB (1 W, 1 m)
Frequency Response
80 Hz – 20 kHz
Crossover Frequency
2.5 kHz
Speaker
Coaxial speaker
Low frequency : 25 cm cone speaker
High frequency : CD horn (60° x 60°) plus compression driver
Input Terminals
Push-in terminals
Anchor Bolt Installation
Anchor bolt receptacle (anchor bracket) attached.
Ceiling Hole
Round hole with diameter of 320 mm
Enclosure Depth
200 mm
Materials
Enclosure : Wood (Medium density fiber or MDF)
Anchor bracket : Steel plate
Weight
6.8 kg (including an anchor bracket)
Note: The design and specifications are subject to change without notice for improvement.
• Accessories
Sliding retainer clip ............................................................................................................ 4
Wing bolt (M4x8) ............................................................................................................... 4
Pattern papers (one for round hole and one for anchor bolt position setting) ................... 2
Safety wire ......................................................................................................................... 1
