6. Signal Tone Switch
A siren tone sounds when
this switch is pressed, and
stops when it is pressed
once again.
Note
Output volume is fixed, and
can not be adjusted with
the volume control.
7. Handle (ER-3215S-AS)
The
handle
with
anti-bacteria
treatment
improve
hygiene
and
safety during use.
8. Stand Socket
The megaphone can be
mounted on the optionally
available ST-16 Speaker
Stand using the threaded
hole on its bottom.
For mounting details, refer
to the ST-16 instruction
manual.
9. Volume Control
Rotate upward to increase
output volume.
Volume
High
1. Speaker (outer horn)
2. Shoulder Strap
Use this strap to hang the
unit from the shoulder for
transport or use.
(Length: approx. 1 m)
3. Battery Cover
The battery compartment
is built inside. Turn the
cover counterclockwise to
open it and clockwise to
close it.
4. Microphone Hanger
Hook the microphone onto
this hanger.
Pressing either talk switch
Note
To avoid damage, do not
use excessive force when
hooking the microphone.
5. Talk Switch
Press to talk (power turns
ON). Release to turn the
power OFF.
Note (only ER-3215S-AS)
turns the power on for use.
7. HOW TO USE
Step 1
Detach the microphone from the microphone hanger.
Note
Use the talk switch on the handle to activate the
megaphone for use, even when the microphone is
attached to the hanger. For ER-3215S-AS, the hanger
can rotate 360° to allow easy microphone positioning.
Step 2
Using the volume control, adjust the volume to an
appropriate level that does not generate feedback when
holding down the talk switch.
Howling is more likely to occur when using the
megaphone indoors or in other reverberant places.
Particularly when the batteries are new, it may be
impossible to adjust the volume to maximum without
causing howling. In such cases, set the volume to about
mid-level.
Step 3
Speak into the microphone while holding it about 1 cm
away from the mouth.
Note
Speaking too far from the microphone or in too soft voice
may result in insufficient volume.
[When Attaching the Microphone]
Reduce the volume to its lowest setting, then press the
microphone onto the hanger. Leaving the volume set higher can
cause howling if the talk switch is accidentally pressed when
attaching or removing the microphone.
6. REPLACING THE BATTERIES
Step 1
Rotate the battery cover counterclockwise to remove it.
Note
Detach the microphone from the hanger in advance.
Step 2
Insert six C batteries referring to the polarity diagram on
the inside of the battery compartment.
Step 3
Insert the tab on the inside of the battery cover into the
slot in the battery compartment as shown and turn the
battery cover clockwise until tight.
Close
Open
Battery Cover
Tab
Battery Case
Slot
Polarity Diagram
TOA Corporation
CAUTION
•
Before pressing the talk switch, fully turn down the volume.
•
Point the megaphone toward the ground when conducting
operational tests.
at the handle or microphone
133-03-00003-00
URL : http://www.toa.com.sg/
Traceability Information for Europe
Manufacturer:
PT. Toa Galva Industries
Jl. Raya Jakarta Bogor Km. 34-35 Sukamaju baru
Tapos 16958 Depok - Indonesia
Authorized representative:
TOA Electronics Europe GmbH
Suederstrasse 282, 20537 Hamburg,
Germany
(ER-2215S-AS)
