background image

6. Move the cursor with the

and

keys to select "EXECUTE," then press the MENU key. 

"YES" and "CANCEL" indications are displayed. "DISK MODE" is factory-preset to "NORMAL."

7. Move the cursor with the

and

keys to select "YES," then press the MENU key.

The confirmation message is displayed after hard disk initialization completion.

8. Select "OK," then press the MENU key. 

The display returns to the hard disk initialization screen.

9. Press the

key several times to exit the Menu screen.

The display returns to the normal screen.

10. Turn off the DVR power.

Place the DVR in standby mode by pressing the power key for 2 seconds or more, then disconnect the
power supply plug from the wall outlet.

133-41-006-2A

URL:  http://www.toa.jp/

V e r

.

S Y S T E M

C H E C K

I N

P R O G R E S S .

P L E A S E

W A I T .

3. HDD INITIALIZATION PROCEDURE

Initialization is required after installing a new HDD.
Unless initialization is executed, hard disk error occurs, and the DVR cannot be used.

Note

Do not disconnect the power supply plug while the power key is lighting. Be sure to place the DVR in standby
mode before removing the power supply plug.

1. Connect the power supply plug to the AC wall outlet.

The DVR is placed in standby mode, and the power key flashes at about 5-second intervals.

2. Press the power key in standby mode.

The screen is displayed and automatically changes as shown below.
The power key flashes green during system check.

Note:

The DVD cannot be switched on for about 20 seconds after it has been placed in standby mode.

The power key changes from flashing to steady ON after system check completion. In this event, the
buzzer sounds and the failure indicator flashes. To stop the buzzer, press the ALARM RESET key.

3. Hold down the MENU key for 2 seconds or more.

The Main menu screen is displayed.

4. Move the cursor with the

and

keys to select "MAINTENANCE," then press the MENU key. 

The Maintenance screen is displayed.

5. Select "HD INITIALIZE," then press the MENU key. 

The hard disk initialization setting screen is displayed.

Содержание C-DR091D PL

Страница 1: ...ies Note Be sure to use the recommended hard disk drive Failure to do so could cause a recognition failure or data reading writing errors 2 HARD DISK DRIVE HDD INSTALLATION PROCEDURE Notes Be careful when handling a HDD The HDD is a very precise device and can be damaged by static electricity shocks and vibrations 2 1 Settings DIP switch setting and cable connection must be changed when installing...

Страница 2: ...DVD drive Factory default setting DIP switch 3 Change the DIP switch setting as shown in the table below 5 Replace the DVD drive removed in Step 2 4 Change the cable connection as shown in the below DVD drive Remove CN2003 CN4 CN5 Change CN2004 Change Factory default setting Setting after change DVD drive connection signal CN2004 CN2003 power supply CN5 CN4 ...

Страница 3: ... capacity In case of a single HDD HDD HDD HDD 2 2 HDD Installation 1 Remove the mounting brackets attached inside of the Digital Video Recorder DVR then attach them to the HDD Secure the HDD to the chassis 2 Connect both the signal cable and power supply cable to the HDD ...

Страница 4: ...ard disk error occurs and the DVR cannot be used Note Do not disconnect the power supply plug while the power key is lighting Be sure to place the DVR in standby mode before removing the power supply plug 1 Connect the power supply plug to the AC wall outlet The DVR is placed in standby mode and the power key flashes at about 5 second intervals 2 Press the power key in standby mode The screen is d...

Отзывы: