7
7. CONNECTIONS
7.1. Power Supply Connections
[If using an AC/ DC adapter]
7.2. Audio Input Connections
(Refer to CONNECTOR CONNECTIONS on the previous page for how to connect the connectors.)
[If using a dynamic microphone]
Note: Make sure that the dc power supply is switched OFF during cable connection or disconnection.
DC IN 12V
AC adapter
Connect to
AC mains
Connect to 12V DC (350 mA or more)
C
H
C H
PHANT
MIC/
LINE
[If using an electret condenser microphone]
C
H
Lead wire of approx. 30mm in length.
C H
PHANT
MIC/
LINE
1. Connect cable conductor to "H" and shields to "C."
2. Set the front panel-mounted Input level selector switch to the MIC position.
3. Adjust the volume control so that voice output is not distorted.
1. Connect both the microphone cable conductor (HOT) and lead wire to "H."
2. Connect the shields to "C", then connect either end of the lead wire to "PHANT."
3. Set the front panel-mounted Input level selector switch to the MIC position.
4. Adjust the volume control so that voice output is not distorted.