TN’G Milano 49cc, Руководство пользователя

Страница: 16 / 33

16
Battery
The battery is a “maintenance free” type. It should not require electrolyte
replacement.
To maintain a full charge on the battery, it is best to use the kick
starter for short trips. Always charge the battery before storing the scooter for
long periods of time. Open the battery plate on the floor board to expose the
battery. If the battery posts appear to be dirty or have a white powder on them,
they will require cleaning. This is done by:
„ Check to see that the ignition is turned off.
„ Disconnect the negative wire first, then the positive wire from the battery
and lift the battery out of the battery compartment.
„ Use a wire brush to clean the battery posts.
„ Gently wash and dry the battery before replacing it into the scooter.
„ Reverse the steps above to reinstall the battery into the scooter.
„ Review the battery installation steps on page 8 for more detailed instruc-
tions on reinstalling the battery.
Rear Drive
Examine the rear drive assembly for any
signs of oil leakage. There is no way to
accurately measure the oil level. The rear
drive oil should be changed if the oil level
is suspected of being low.
The rear drive oil is changed by:
1) Find the rear drive drain plug at the
rear of your scooter. It’s hard to see,
but it’s located on the left side of the
scooter near the rear wheel under-
neath the rear drive assembly.
(See Fig 19 & 20)
2) After placing a suitable container
under the drain plug, use a wrench to
unscrew the plug and let the fluid
drain out.
Fig 19
Fig 20