W W W . T M G I N D U S T R I A L . C O M P 1 4 / 2 0 T o l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9
Step 7 : Install front and rear cover panel
The door cover must be zipped. Use rope (#24) to lift up the front cover (#23)
from the center grommet and tie it firm to the truss tube and spread toward
both sides through each grommet along the tube. Refer to Figure 9 and 10 on
how to attach the rope and tie to the tube.
Insert the dropping tube (#15) into the bottom groove pocket on the door
cover. Tie two ropes (#20) separately on both sides of the peak arch tube. Pull
both ropes under through the bottom of the door cover from the back, then go
up from front and through both pulley (#11A) and (#11B) (figure 9).
Parts used in this step :
- (1x2) Door dropping tube (#15)
- (2x2) Nylon rope (#20)
- (1x2) Front and rear cover panel (#23)
- (1) Braided rope (#24)
(Figure 9 - view from inside)
