TMG TMG-RT83, Руководство по эксплуатации продукта

Страница: 18 / 35

www.tmgindustrial.com 18/35 Toll Free:1-877-761-2819
CHECK BEFORE OPERATING
1. Check before operating
1. Check the various parts of the tractor
Please check the parts according to the manual
2. Check the connection site
(1) Fix connection pin of three-point suspension
(2) Check the stand foot retract
3. Check the coupling
(1) Whether the coupling ends effectively connected with the machine and tractor
(2) Security chain is valid is fixed.
(3) Plastic protective cover is complete.
(4) Security chain sag length is appropriate.
4. Rotary tiller machine inspection
(1) The cutter blade bolts are tightened.
(2) Whether the gearbox rotation is normal, the hydraulic oil in gearbox not exceed the volume of 1/3,
if less need to add gear oil.
(3) The various parts of the bolts and nuts are tightened.
(4) The oil in each parts should be adequ
2.Check during engine starting
1. Check the drive system
The new machine or machine long unused, you must first idling operation.
(1) Start the tractor engine and low speed transfer to PTO.
(2) The engine speed was adjusted to 1000 rev / min mode, idling about 5 minutes.
(3) if the above normal, the rotational speed was adjusted to 500-540 rev / min mode, idle for about
5 minutes.
If the drive system has a problem, you can refer tractor manual investigation.
2. Check the tractor hydraulic system
Operate tractor three-point suspension lift handle and hydraulic output handle, lifting and turning the
machine to ensure no problems.
If you have questions, please contact the tractor dealer.
⚠ Danger
● If start the engine when the PTO does not cut off the power ,it may cause harm to the people around.
Always switch off the PTO and then start the engine.
● When starting the engine, if it does not lower the rotary tiller is approaching, has no intention of falling or
rising, people around may cause injury. Keep machine is approaching low before starting the engine.