NanoCam3D Mk.1 Instruction Manual
IMPORTANT – READ CAREFULLY BEFORE USE
KEEP FOR FUTURE REFERENCE
Power on camera and release push button 2. The camera’s status LED starts to flash.
Flashing cycle indicates current 3D-mode and image swap setting (SBS no swap =
repeated single flash, SBS swapped = repeated double flash, FS no swap = repeated triple
flash, FS swapped = repeated quadruple flash).
Press and release push button 1 to toggle between these 4 possible modes. LED flash
cycle changes accordingly.
Press and release push button 2 to save setting and restart camera with new setting.
2.4 Reset to Factory Default Settings
It is possible to reset the camera to default settings by executing the following procedure. Notice
that also the camera’s adjustment settings (see following chapters) will be erased.
Power off camera.
Press both push buttons 1 and 2 and keep them pressed.
Power on camera, LED flashes fast.
Release both push buttons to execute camera reset and to restart camera with factory
defaults.
2.5 Sensor Vertical Adjustment
Manufacturing tolerances sometimes lead to vertically misaligned left and right images. This effect
is most prominent in side-by-side 3D mode (Figure 3).
The camera is able to compensate such misalignment without loss of resolution or black bar
padding as the utilized image sensors provide extra video pixels for that purpose. Follow the
procedure outlined below for vertical sensor adjustment. The procedure can be canceled at any
time by power-cycling the camera.
Power on camera and display video signal on a suitable test monitor or video goggle. The
adjustment should be made in side-by-side 3D mode.
Press push button 1 and keep it pressed for ca. 1 sec until the status LED flashes fast, then
release push button 1.
Page 6 of 12
Subject to change without notice.
EN
Figure 3: Vertically misaligned images (left) and correctly aligned images (right)
