8
2.8 Conduct in case of gas leaks
If you smell gas, proceed as follows!
If you smell gas, do not ignite the device and close the cylinder valve by turning it clockwise.
Do not touch any switch and do not use the phone.
Open doors and windows to ventilate the room.
Extinguish any flame or other potential ignition sources.
No naked flames and no smoking.
Carry out the test operations indicated in 3.4. Never carry out the test in the presence of naked flames.
If there are no leaks, ignite the stove taking special care and in compliance with the instructions provided in
the user manual.
If you still smell gas, try to replace the cylinder as the gas may contain an excessive amount of aroma
compound.
If the problem is not solved, contact the distributor or a specialized technician.
Do not use the appliance until it hasn
’t been inspected by a qualified technician.
Never attempt to make any repair work yourself.
Failure to observe this warning may result in injuries or damage to property.
3. Preparing the appliance for operation
3.1 Opening the packaging
Upon delivery, check that the appliance is complete and in perfect conditions.
If there are missing components or faults, do not use the product and contact the seller immediately.
3.2 Keeping the original packaging
Keep the original packaging for the whole life of the appliance.
Use the packaging to store and transport the appliance.
Dispose of the packaging at the end of the life-cycle of the appliance. For further information on correct
disposal, please refer to chap. 8.
3.3 Connecting the stove to the gas bottle
Never position the cylinder upside-down!
When connecting the cylinder for the first time, and any time the cylinder needs to be
replaced, ensure that the room is well ventilated and that there are no naked flames. Do not
smoke while carrying out these operations.
If the cylinder has been transported, store it in upright position for at least 1 hour before
using it.
Ensure that the gas seal on the cylinder is intact and in perfect conditions.
Check that the connections (the regulator ring and the thread on the cylinder valve) are
clean and undamaged.
Connect the cylinder outside the appliance, as illustrated here below:
Read thoroughly before use.
GB
The following operations are required for the connection:
- Only use this regulator on a Butane gas cylinder with a 21mm (G53) cylinder valve.
- The LP nozzle outlet connection shall only be connected to 8mm Tubing to BS3212 Type 1, 8mm
Hose to BS3212 Type 2, 8mm Tubing to BS EN 16436 Class 1, 8mm Hose to BS EN 16436 Classes 2 or 3.
- The gas cylinder must always be in vertical position and the regulator must never be disconnected while
the appliance is turned on.
- Make sure that the hoses are kept clear of hot surfaces and inspect before use. Replace any hose that
shows signs of wear, cracking or other damage.
- In case of gas escape or malfunction, close the gas supply and contact your dealer.
- Do not use a flame to test for gas leakage: Use a soapy water solution.
