TMC Radio SRP 9100, Руководство по обслуживанию

Страница: 57 / 66

A1
Page
5.9
6 ~ CIRCUIT DIAGRAMS
TNM-M-E-0012 Issue 1.23
5.2.3.4 Mute/Audio Balance Adjustment
Note. This adjustment has default setting of 1000/2600 and should not need changing except for specific
requirements.
1. Select the Mute/TCXO page and select Open Mute.
2. Set the RF signal generator to the receiver alignment frequency, and adjust the RF level such that the
desired mute opening SINAD (typically 10dB SINAD) is achieved.
3. Select Mute Closed and remove the RF input from the radio .
4. Select the Mute/TCXO page
5. Set the Squelch Open and Squelch Close sliders to the fully left position. This ensures the receiver
will be muted.
6.
Set the Squelch Close slider to the fully right position.
7. Reconnect the RF input to the radio.
8. Adjust the
Squelch Open
slider to the right until the mute opens.
9. Reduce the Signal Generator output level by approximately 2dB (or by an amount equal to the
desired mute hysteresis level).
10.
Adjust the Squelch Close slider to the left until the mute closes.
11. The mute should now open and close at the desired RF levels.
12. Unsquelch the radio and set the radio volume to minimum.
13. Monitor the DC voltage across the speaker or load.
14.
Adjust the Rx Audio Balance DAC to achieve a minimum in the measured DC voltage (within
0V±10mV) and leave at this setting.
15.
Note. On revision 2 radios and higher, an additional Tx Audio Balance DAC is also provided .
For these radios, the Tx Audio Balance DAC is defaulted to zero for normal setting. However, for a
more accurate setting, the DC voltage at TP731 needs to be noted during Rx and adjusted by the Tx
Audio Balance DAC to give the same reading (to within 10mV).