Inhaber: Hans Vollmer
Epfentalstrasse 14
78052 Villingen-Schwenningen
Deutschland
Tel: +49 7721 908701
E-Mail: [email protected]
Web: https://www.tlpbf.de
UST-ID: DE334059283
Volksbank EG Die Gestalterbank
IBAN: DE32 6649 0000 0082 6400 02
BIC: GENODE61OG1
Voltage = 8,2V Voltage = 9V
To set the desired voltage, insert the jumper as shown above.
QCP-Stick 12V configuration:
The QCP stick 12V is permanently set to 12V. The jumpers have no function.
QCCP-Stick and Powerbanks:
The QCCP-Stick and the QCP-Stick 12V are designed to work with most Powerbanks with
a few exceptions. Detailed information can be found in the power bank compatibility list
at the end of the manual.
For power banks that are not listed in the compatibility list, the function can be tested as
follows:
To do this, connect the adapter to the power bank without a camera connected and wait
approx. 1 minute. If the PB does not switch off during this time, the adapter will work with
this PB without any problems. However, if the PB switches off after a short time, at least
the USB-A port is not designed to function with the QCCP-Stick. In this case, connect the
adapter to the USB-C port using the OTG adapter and repeat the test. All PBs tested so far
with the QCCP-Stick functioned on the USB-C port.
Connection of the QCCP-Stick to the USB C port
The QCCP stick is equipped with a USB A connector. A USB-OTG adapter must be used to
connect to a USB C port. These are available in different versions.
