5 Installation
This chapter contains instructions for mounting the CEDD
®
HPS Basestation vertically.
Before installing the CEDD
®
HPS Basestation read the Installation Safety on page 16 instructions below.
•
Disregarding these safety instructions will result in the loss of warranty in case of
damage. TKH Airport Solutions is not liable for any injuries to personnel or any
equipment damage.
5.1 Installation Safety
•
Install all electrical connections according to local safety codes.
•
Use only electrical wiring of sufficient gauge and suitable insulation to conduct the
rated currents. All wiring must meet local safety codes.
•
Route electrical wiring along a protected path. Make sure the wires will not be
damaged by moving equipment.
•
Protect components from damage, wear and harsh environmental conditions.
•
Allow ample room for maintenance, panel accessibility, and cover removal.
•
Protect equipment with safety devices as specified by applicable safety regulations.
•
If safety devices must be removed for installation, re-install them immediately after
installation has been completed and check them for proper functioning prior to
returning power to the circuit.
•
Always tighten the bolts to the recommended torque. Use a calibrated torque wrench
and apply the recommended locking agent.
•
Failure to observe the above warning can cause the bolts to loosen, which will
damage and potentially loosen the equipment. This can lead to highly dangerous
situations with potentially fatal consequences.
•
Condensation damages the CEDD
®
HPS Basestation and can cause serious injury or
death. See Acclimatization on page 17 on how to prevent condensation.
16
Installation and Maintenance Manual - CEDD
®
HPS Basestation
©
TKH Airport Solutions 2022. All rights reserved. All specifications subject to change without notice.
