- 10 -
10
v.
The tool is now ready to operate.
TOOL OPERATION
SEQUENTIAL OPERATION:
The sequential operating prevents successive or “bounce” driving.
Depress the work contacting element and hold it against the work
surface before pulling the trigger.
After each fastener is driven, completely release the trigger and
lift the tool from the work surface.
OPERATING THE TOOL:
Be sure to locate and insert the first T-nut barrel into the
pre-drilled hole of work piece with finger off the trigger.
Depress the tool vertically and pull the trigger to drive a T-nut.
Remove finger from the trigger and lift the tool from the work
piece.
Repeat the same procedure for next T-nut.
When change the T-nut size, remove the remaining T-nuts inside
the magazine.
For best result to operate the tool:
When tool/T-nut is located in hole, pull the tool backwards
(toward yourself) and pull the trigger.