Tivok T-HP20AB, Инструкция по установке и эксплуатации

Страница: 12 / 34

Tivok Energy T-HP20AB Heat Pump Installation Manual
10
CONTROLLER OPERATION
CONTROLLER ILLUSTRATION
On/Off
Press it to switch on or off heat pump.
Mode Selection
Press it to select the mode. The sequence is: cooling-
heating.
Long press it for more than 6 seconds and heat pump will
enter defrosting mode.
During parameter setting, press it to adjust parameters;
During clock and timer setting, press it to choose the hour
value or minute value.
During parameter setting, press it to adjust parameters;
During clock and timer setting, press it to choose the hour
value or minute value.
Up and Down
Press them to adjust the value of water temperature, clock,
timer and parameters.
During failure checking and parameter checking, press any
of them to exit checking.
Parameter Setting
Long press it for more than 6 seconds, you can check and
adjust the parameters.
Press the UP/DOWN key to exit operation.
When a failure occurs, press it for no more than 2 seconds,
you can check the failure code.
Press it again you can check the other failure code if more
than one occurs.
Press the UP/DOWN key to exit checking.
Clock and Timer Key
Press it to set clock and timer. Detailed operation will be
described in following pages.
During parameter setting, press it to change the rolling
direction of parameters.