Titon aura-t TP536/EU, Руководство по эксплуатации продукта

Страница: 34 / 40

Maintenance
aura-t
The aura-t is maintenance free.
Cleaning Exterior
For best results use a clean damp micro fibre cloth. Do not use abrasive cleaners, waxes, solvents or alcohol based cleaning
products; do not use paper towels for cleaning the
aura-t .
HRV
All ventilation units require periodic maintenance. Routine maintenance,
apart from filter changes, must only be carried out by a suitably qualified and
competent person.
WARNING: The unit uses a 230V ~ supply and contains rotating mechanical
parts. ISOLATE the unit from mains power supply and allow sufficient time
for all moving parts to stop before undergoing any Servicing or Maintenance.
The unit may be supplied with multiple live supply if a Duct Heater is fitted
or uses switched live for Boost Speed control.
Front Cover Removal
1. ISOLATE the unit from mains power supply and allow sufficient time for all
moving parts to stop
2. Loosen the two corner screws located on the bottom front of the unit
3. Completely remove the centre screw
4. Completely remove the Front Cover by pulling it away from the unit at the
bottom and lifting
Cover replacement is the reverse of the above steps. Ensure it is securely located
at the top before tightening screws.
Cleaning Interior
For best results:
1. Slide out Filter Frames fitted either side of heat exchanger
2. Carefully remove any dust from face of heat exchanger, interior of the unit and the Bypass(if fitted) using a vacuum
cleaner
Do not use water or any other fluids
Cleaning Exterior
For best results use a clean damp cloth. Do not use abrasive cleaners, solvents or any other fluids.
Condensate Tray
If the Condensate Tray is split a replacement must be ordered and fitted.
HRV3 Part No. XP40142/012
100mm M
AX
1
2
34