Titanium 88190, Инструкция по эксплуатации

Страница: 8 / 12

8
EN
POWER SUPPLY
• The detector is powered by one 9V alkaline battery.
Battery replacement
• Remove the
battery cover door and the batteries.
• Insert the batteries according to polarity and replace
the battery cover door .
MOUNTING TO THE STAFF CLAMP
• Insert the staff clamp screw into the staff clamp
mounting point.
• Rotate the staff clamp thumb screw until the clamp
is secured in place.
DETECTOR OPERATION
• Power the detector on by pressing the power button.
The LCD screen will turn on and the speaker will emit
a small tone to indicate the instrument is operating.
• The LCD screen will display the battery level,
detection mode and speaker function.
• To change between broad, coarse and fine mode
press the detection mode button.
• To change the speaker volume or turn the speaker
off, press the speaker button.
• To turn on the backlight, hold down the mode
button for approximately 3 seconds.
• Move the detector into the path of the laser beam.
• Hold the detector upright for horizontal beams (Fig. 2) or
rotate 90° for vertical beams (Fig.3).
•
The direction arrows or level line on the LCD screen
will indicate the position of the laser beam. A digital
measurement of either how far up or down the detector is
from the laser line will also be displayed (Fig. 2 & 3). The
detector will emit a constant beep once the level position
has been located (Fig. 4).
Fig. 2
Fig. 3
Fig. 4
MILLIMETRE DETECTOR & CLAMP (continued)
1 Plus & minus indicator
2 Measurement
3 Arrow indicator
4 Unit of measure
5 Centre alignment 6 Detection mode
7 Brightness indicator
8 Battery indicator
9 Speaker indicator
3
1
6
7
9
2
4
8
5
DETECTOR LCD SCREEN OVERVIEW