IMPORTANT:
Always be sure to “test” the device BEFORE sending the asset into the field
NO Input Cable
a) Ensure device is OUTSIDE with a clear view of the sky
b) Remove Magnetic Grommet
c) Ensure current location of the device is displayed on your Titan GPS account. (This can
take up to 35 minutes)
d) If successful, leave the Magnetic Grommet removed and store for future use.
WITH Input Cable
The input cable can be used for monitoring the status of various inputs. The most common
is for asset engine hours. In order to see input status changes, the testing process will need
to force packets through. These will contain the input status. Please see the process below
for testing an ignition/engine based input. Other inputs will follow a similar process.
a) Ensure device is OUTSIDE with a clear view of the sky
Stage 1: Input OFF test
b) Ensure asset ignition or input that you want to monitor
is OFF (Eg. Ignition is Off)
d) Ensure input cable wiring is connected to the input
wiring (E.g. Ignition)
e) Remove the Magnetic Grommet from the device
f) View the device on your Titan GPS account
(This may take up to 35 minutes)
-A “Unit Turned On” package will be displayed
-The desired input status should = Off (E.g. Input 1: Off).
Stage 2: Input ON test
g) Reattach Magnetic Grommet to the device and wait 2 minutes
h) Turn desired asset input ON (E.g. Ignition)
i) Remove the Magnetic Grommet from the device
j) View the device on your Titan GPS account (This may
take up to 35 minutes)
- A “Unit Turned On” package will be displayed
- The desired input status should = On (E.g. Input 1: On).
k) If successful, leave the Magnetic Grommet removed and
store for future use.
Troubleshooting
(If the location is not updating on your Titan GPS account;)
-Ensure device has a clear view of the sky
-Try “resetting” the device by turning the device switch OFF, waiting 5 minutes, then turning
device switch ON.
CARE AND USE
The clear plastic on the TT1SPSATsolar should be kept free of soil or debris to
maximize battery charging capacity
Solar panels produce the most electricity when they are perpendicular to the sun
Shading and weather conditions may negatively affect the charging of the batteries
from the solar panels
If the batteries of the TT1SPSATsolar are fully depleted, it is recommended to allow
the device to receive a full day (6+ hours) of adequate sunlight to fully charge the
batteries
If the clear plastic panel covering the solar panel becomes cracked, the device should
be replaced
The device should provide up to 10 years of maintenance-free operation based on
adequate sun exposure to recharge the battery pack. The internal battery pack is not
replaceable.
If the asset is to be stored indoors for extended periods of time, the TT1SPSATsolar
should be shut down be installing the Magnetic Grommet to avoid draining the
battery pack. Be careful to store the Magnetic Grommet when removed.
A fully charged TT1SPSATsolar should remain operational up to 6 months with a
clear view of the sky in the absence of sunlight if programmed with two GPS locations
per day
STEP 4:
Testing the Device
QUICK INSTALL GUIDE
TT1SPSAT
solar
Magnetic Grommet
1 855 287 4477 | 1-780-391-3800 | 8AM to 5PM Monday to Friday MST
titangps.ca | titangpstracking.com
CALL US
WE’LL TEST
WITH YOU
