TITANCUT 40 PFC, Руководство по эксплуатации

Страница: 21 / 44

TitanCut 40 PFC Operators Manual Issue. A 0516
Gas Connection
Connecting Gas Supply to Unit
Connect the gas line to the inlet port of the gas filter on the rear panel.
Check Air Quality
To test the quality of air, put the RUN / SET switch in the SET (down) position, check if there is Any
oil or moisture in the air .
Working connections
Connect cutting torch, earth cable & regulator,according to connection diagram. Gas supply can be
either air or Nitrogen. A high pressure regulator must be used on either type of gas and must be
capable of delivering 155 l/min at a pressure of 57 psi ( 3.9 bar) to the filter.
Mains supply – TitanCut 40
The INPUT primary cable is supplied with machine. Connect the machine to mains
according to your state legislation of where machine is being used. Connection can
be effected through plug or direct wiring. Supply system should be protected at all
times by the fuse stated in technical data section. Direct connection to mains can
be done by qualified electrical technician only.
Australian 240V Single Phase Plug variants – AS/NZS 3122
DO NOT USE FITTED FOR COMMISSION RECOMMEDED TYPE