Titan UMAP 2110, Руководство по установке оборудования и инструкция пользователя

Страница: 13 / 62

1
—
Installation of the UMAP 2110
1.2 Hardware Installation
The hardware installation for the UMAP 2110 is simple and without complex hardware setting.
However, it should be installed following out the standard installation procedures. During
installation, basic safety precaution should always be taken, especially, be sure to wear an antistatic
wrist strap to prevent static electricity from damaging the system and injury to the operator. Handle
electronic components as little as possible.
This chapter provides the UMAP 2110 system hardware installation procedures and install samples
for reference. Please perform the procedures in the suggested order.
1.2.1 Installation Overview
The installation consists of the following procedures. Each procedure will be explained in detail in
the following sections:
Step 1: Mount the system into the desired location of a rack.
Step 2: Turn the power switch in OFF position. Connect to the DC power supply, and then
check the voltage. Make sure the power switch is in OFF position before wiring the
power cable and grounding.
Step 3:
Connect FAN cable.
Step 4:
Connect the cable between system and MDF.
After executing the previous procedures, please check the cable connection robustness and
correctness before turning on the power supply.
Step 5: Connect Console cable to COM port of a computer. Then run the terminal program with
the setting shown below:
Figure 1-1 Console Setting
Users can also access the DSLAM via Ethernet. By default the out-band IP address of
the DSLAM is obtained via DHCP. Users can also set the IP address manually by using
the CLI commands or Web Configuration Tool (refer to section 1.3). It’s possible to
access the DSLAM with telnet on port 23.
5 / 54