Titan UMAP 2110, Руководство по установке оборудования и инструкция пользователя

Страница: 12 / 62

1
—
Installation of the UMAP 2110
1.1 Pre-Installation
This section provides the information users have to ware before installing the UMAP 2110. The
information includes required installation tools, safety requirements, and electrostatic discharge
protection.
1.1.1 Tools and Test Equipment Requirements
To install and maintain the UMAP 2110, you should have the tools and test equipment listed in the
Table 1-1.
Table 1-1 Required Installation Tools and Materials
Item Required Purpose
Anti-static wrist strap Protect the UMAP 2110 system from electrostatic
discharge damage.
Hand tools Screw drivers for equipment removal and replacement.
Wire cutter/stripper Prepare wires for electrical connections.
Accessories and hardware kit Screws, bolts, etc., for securing the equipment on the
desired location.
1.1.2 Safety Requirement
To prevent possible serious injury, do not apply power to the UMAP 2110 system at the central
office or any remote site until you’ve completed all of the installation procedures and connected it to
the external facilities. Be cautious, when turning on/off the UMAP 2110 system power.
1.1.3 Electrostatic Discharge Protection
The terminal cards contain static-sensitive components. When handling them, be sure to wear a
properly grounded anti-static wrist strap to prevent the damage from electrostatic discharge. If a
wrist strap is not available, hold all cards only by their edges or extractor handles. Do not touch any
component or traces on the cards. For future use, store cards in original shipped antistatic bags, or in
an approved static-protected bag or container.
To minimize the possible damage from electrostatic discharge, do not install the UMAP 2110 in
cold, dry places where static electricity can build up. Also, when handling cards, do not touch their
rear-edge connector traces. These electrical contact points should be kept free of body oils and other
contaminants.
4 / 54