Titan TTL650GDO, Инструкция по безопасности и эксплуатации, Страница: 17 / 27

d). Never stand directly under the limb you are sawing. Objects may fall different than
expected. Always position yourself out of the path of falling limps. (See Fig. 14a)
e). Keep other persons away from cutting end of product and at a safe distance from the work
area. Maintain a minimum distance of 15 m to bystanders. (See Fig. 14b)
WARNING! Never climb into a tree to prune! Do not stand on ladders, platforms, logs,
or in any position which may cause you to lose your balance or control of the product!
When pruning trees, it is important not to make the flush cut next to main limb or trunk
until you have cut off the limb further out to reduce the weight! This prevents stripping
the bark from the main member!
f). Never stand on a ladder or other type of unstable support while using the product. Insecure
stand invites hazards. (See Fig. 14c)
WARNING! This product has not been designed to provide protection from electric
shock in the event of contact with overhead electric lines! Therefore do not use product
near cable, electric power or telephone lines. Keep a minimum distance of 15 m to all
electric lines. (See Fig. 14d)
Fig. 14b Fig. 14a
Fig. 14c
Fig. 14d
g). Use the product only with secure footing. Hold the product at the right-hand side of your
body.
h). Do not operate the product with arms fully extended or attempt to cut areas which are
difficult to reach.
i). Keep a firm, steady pressure on the product while working with it. Do not try to force the
product through the wood, let the cutting device do the work, using the gripping teeth to apply
minimal leverage pressure.
j). Beware when reaching the end of the cut. The weight of the product may change
unexpectedly as it cuts free from the wood. Accidents can occur to the legs and feet. Always
remove the product from a wood cut while it is running.
NOTE: The chain must be running at full speed before it comes into contact with the wood.
4. Cut thin branches
Thin branches can be cut off with one single cut. To prevent the branch from slivering and
buckling the branch should be cut off in several pieces. (See Fig. 15)
Fig. 15
Pole Pruner Attachment TTL650GDO