EN
24
In
more
detail...
TTI885IPD
EN
Product functions
Intended use
This product is intended for tightening and loosening screws, bolts, nuts with
respective driver/hex nut driver bits. It must not be used for drilling and should
not be used for working on materials that are dangerous to health. It must not be
used for tightening or loosening car wheel nuts.
operation and to observe all the instructions therein.
It must not be used for any purposes other than those described.
Forward / reverse rotation control
Change the rotation direction from forward to reverse by pressing the
forward / reverse rotation control (4).
WARNING!
Only change the rotational direction when the product is
switched off and has come to a complete stop! Always ensure that the
forward / reverse rotation control is adjusted to the correct position
depending on the intended operation!
Always push the forward / reverse rotation control as far as it will go!
Do not use the product with the control switch in any other position!
1. Move the forward / reverse rotation control switch (4) to the left (as seen from
the operator’s position) in order to use the product in a clockwise rotational
mode (Fig. 5).
2. Move the forward / reverse rotation control switch (4) to the right (as seen
from the operator’s position) in order to use the product in anticlockwise
rotational mode (Fig. 6).
3. Move the forward / reverse rotation control switch (4) to the centre position to
lock the on/off switch (5) and avoid accidental starting (Fig. 7).
Position
Rotational
direction
Application
4
Fig. 5
Screw driving
MNL_18V IMPACT DRIVER_MID18-LI_IMGB_V1_211224.indd 24
2021/12/23 10:31 PM
