Fig. 1
Fig. 2
OPERATIONS INSTRUCTIONS
Note
:
Before using the tool, read the instruction
book carefully.
INTENDED USE
This cordless impact drill driver shall be used for drilling
metal or wood or similar materials, and occasionally for
impact drilling on masonry or similar materials. Other uses
for the tool will lead to the damage of the tool and a series
of dangers to the operator. This tool is intended for DIY
home use, or occasional professional use.
BEFORE USING YOUR CORDLESS DRILL
Your battery pack is UNCHARGED and you must charge
once before use. When you charge the new battery or one
which has not been used for long periods of time, it may
not reach full charge until after you have discharged it fully
in use and recharge it several times.
WARNING:
The charger and battery pack are
specifically designed to work together so do not
attempt to use any other devices. Never insert or allow
metallic objects into your charger or battery pack
connections because an electrical failure and hazard will
occur.
1. TO CHARGE THE BATTERY PACK
(Fig. 1)
Insert the charger plug into a suitable mains socket. The
power indicator (green) will illuminate. Insert the battery
pack into the charger. Then green light will switch off while
the red light will illuminate to indicate that charging is taking
place. When fully charged, the red light will go out while the
green light switches back on. Unplug the charger and
remove the battery pack.
Warning:
When battery charge runs out after
continuously use or exposure to direct sunlight or
heat, allow time for the tool to cool down before re-charging
to achieve the full charge.
2. TO REMOVE OR INSTALL BATTERY
PACK
(Fig. 2)
To remove the battery pack(6) from the tool, firmly press
and hold in the battery pack release button(5) and slide the
battery pack out of the tool. To install the battery pack, align
raised rib on battery pack with groove inside tool, slide the
battery pack fully onto the tool until the battery pack “clicks”
into position. Make sure the release button on battery pack
snaps in place and the battery pack is secured in tool
before beginning operation.