Titan TTD127DDH, Инструкция по безопасности и эксплуатации

Страница: 18 / 24

PROBlEM SOlUTION
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward and reverse switch, which is on top
of the trigger, is positioned in the lock function.
Unlock the forward and reverse switch putting
it into the required rotation position. Push the
trigger and the drill will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW
IS COMPLETELY TIGHTENED. WHY?
Verify the torque position of the variable clutch,
you can find the variable clutch between the
chuck and the drill body. Position 1 is the lowest
torque (screw driving force) and position 20 is the
highest torque (screw driving force). Position 21
is for drill operation. Regulate the variable clutch
to a higher position to reach the best result.
3. I CANNOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger only
in one direction. Turn the battery around until it
can be inserted into the slot, the red LED light
should turn on when the battery is charging.
4. REASONS FOR DIFFERENT CHARGING
TIMES.
Your charge time can be affected by many
reasons, which are not defects in your product. If
the battery pack is only partly discharged it may be
re-charged in less than 1 hour. If the battery pack
and ambient temperature are very cold then re-
charging may take 1 to 1-1/2 hours. If the battery
pack is very hot it will not re-charge because the
internal temperature safety cutout will prevent it.
If the battery pack is very hot you must remove
your battery pack from the charger and allow your
battery pack to cool first to ambient temperature
and then recharging can be started. If you charge
a second battery pack immediately after the first
then the charger can be overheated. Always allow
at least 15 minutes rest between battery pack
charging.
5. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES.
Charging time issues, as above, and having