NOTE!
Please always determine the optimum speed by making a
trial cut in a scrap piece of material.
For concrete/ stone/ brick, the maximum cutting height shall
not higher than 30mm for single cut to avoid overload.
Warning!
Ensure that you use the correct setting for the maximum
rated speed of the disc used.
Avoid prolonged use at very low speed as this may damage
your tool's motor.
WORKING HINTS FOR YOUR ANGLE
GRINDER
Always start at no load to achieve maximum speed then
start working.
Do not force the disc to work faster, reducing the disc’s
moving speed means longer working time.
Always work with a 10-20 angle between disc and work-
piece. Larger angles will cut ridges into the work-piece and
affect the surface finish. Move the angle grinder across and
back and forth over the work-piece.
When using a cutting disc never change the cutting angle
otherwise you will stall the disc and angle grinder motor or
break the disc. When cutting, only cut in the opposite
direction to the disc rotation. If you cut in the same direction
as the disc rotation the disc may push itself out of the cut
slot.
Always ensure the work-piece is firmly held or clamped to
prevent movement.
For cutting, always work with the wheel guard for cutting.
Fig. 9
