Cutting
>
>
17
TTB599BNS
by TITAN
Product functions
In
more
detail…
GB
IE
WARNING:
Do not attempt to cut wood or masonry with this saw.
Never cut magnesium or magnesium alloy with this tool. Failure to
comply with this waming could result in serious injury
WARNING:
Large, circular, or irregularly shaped material may
require additional means of clamping to be secured in place for
cutting. Use C clamps and blocks to hold material securely. Failure
to comply could result in serious injury.
DANGER:Do not touch the cut material until it cools or you will be
bumed. Failure to heed this waming will result in serious personal
injury.
Secure the tool in place to prevent saw movement or tipping during the cutting
procedure.
Firmly secure the material to be cut using the saws’ vise.
>
>
>
Start the saw by fully depressing the trigger switch and allow the cut-off wheel
to come up to full speed before contacting wheel to material.
Slowly push down the saw arm handle until the cut-off wheel contacts the
material being cut. Use a steady and even amount of pressure to obtain a
uniform cut. Never force the wheel into the material.
When the cut is complete, release the trigger switch and allow the wheel to
stop before raising it ot the full open position.
>
>
>
To use the Quick Release, put the Quick Release tab in the position shown on
the in Figure 3 and push the Vise up against the workpiece. Then tighten the
Vise Crank. When releasing, loosen the Vise Crank about a turn, lift up the
Quick Release, and pull the Vise Crank open.
To cut at various angles (up to 45°), adjust the Angle Scale by loosening the two
Bolts . Adjust the Angle Scale to the desired setting and then tighten the Bolts .
To reposition the Angle Scale, remove both of the Bolts , and reattach the
Angle Scale using the other holes in the Base.
