ROTARY HAMMER 700W TTB589SDS
13
OPERATING INSTRUCTIONS
Note: Before using the tool, read the instruction
book carefully.
Intended use
The machine is intended for hammer drilling in concrete,
brick and stone as well as for light chiseling work. It is also
suitable for drilling without impact in wood, metal, ceramic
and plastic.
Installing the auxiliary handle (Fig.1)
Slide the handle onto the hammer and rotate to the
desired working position. To clamp the auxiliary handle ro-
tates the handle clockwise. To loosen the auxiliary handle,
rotate the handle anti-clockwise.
CAUTION!
Always use the auxiliary handle.
Installing the depth stop (Fig. 2)
Loosen the depth gauge by rotating the auxiliary handle
anti-clockwise. Slide the depth gauge until the distance
between the depth gauge end and the drill bit end is equal
to the depth of hole/screw you wish to make. Then clamp
the depth gauge by rotating the handle clockwise.
Inserting and removing drill bits (Fig.3)
Inserting
Clean and lightly oil the bit before inserting. Insert the
dust-free bit into the bit holder with a twisting motion until
it latches.
The bit locks itself. Check the locking by pulling on the
tool.
Removing
Retract back the bit holder locking sleeve (3) and pull out
the bit.
Fig.1
Fig.2
Fig.3
