29
TTB579PLN
by TITAN
Care and maintenance
In
more
detail…
GB
IE
Caution:
Always wear a dust mask and eye protection when using dry air.
> Remove all chippings etc from the planer thicknesser.
> Remove all chippings etc from around the air inlets of the motor. If these become
blocked the motor will become too hot and its service life will be greatly reduce.
> Wrap the mains lead carefully around the cable clips. This will reduce the risk of
tripping and / or damage to the cable.
After 10 hours running
> Lubricate the bush bearings.
> Treat the threaded spindles for height adjustment of the thicknessing table with
dry lubricant.
Periodically
Over time resin or other contaminates may build up on the planer in-feed
and out-feed tables, as well as the thicknesser table and the in-feed and out-feed
rollers.
> To ensure easy steady feeding the beds and the rollers will need to be cleaned
periodically.
> Periodically check that the anti-kickback fingers (38) move freely (they should
fall back under their own weight).
> Check that the points of the anti-kickback fingers (38) are not rounded.
After each use
> Remove the extraction port and clean out all chippings etc. Dry air would be good
for this operation but a soft brush would also work.
Fig. 32
