Care and maintenance
TTB546BTS
by TITAN
30
In
more
detail…
GB
IE
> The correct belt tension in shown in Fig. 45, with a firm pressure you should be
able to squeeze the belt 5mm on each side. Do not over tighten as this
will damage the motor bearings and belt. The belt should not be slack as it may
run off the pulleys during use.
> The belt tensioners are shown in Fig. 46 “ horizontal adjusters ” (41) & “ vertical
adjuster ” (42).
> When squeezing the belt; If the motor pulley rises, adjust the “ vertical adjuster ”
(42) with 3mm hex key until there is no more vertical play in the motor.
> Remove the old belt.
> Fit the new belt over the lower motor spindle pulley and over the top pulley as
in Fig. 43. To help engage the belt pulley with the top pulley teeth, rotate the
motor spindle counter-clockwise while applying horizontal pressure to the belt
at the top pulley (Fig. 43). Ensure the belt is correctly located on both pulleys.
Fig. 44 shows the belt in the correct location on the upper pulley.
Fig. 41
Fig. 42
Fig. 43
Fig. 44
39
40
