INSTALLATION WIRING INSTRUCTION
l
WARNING isolate the power supply before installation.
It is advisable to install a single pole wall switch (FIGURE 4). This will allow easy control of the floodlight.
1) Undo the four fixing screws from the wiring box cover and remove the cover (FIGURE 5).
2) Unscrew one of the cable glands and using a suitable tool pierce a hole on the cable grommet. Route the HO5RNF
supply cable through the cable gland and grommet (FIGURE 6).
3) Strip approximately 6mm of insulation from each of the 3 cores of the supply cable, refer to FIGURE 7.
Connect the BROWN wire (Live wire) to the terminal marked “L”.
Connect the BLUE wire (Neutral wire) to the terminal marked “N”.
Connect the YELLOW/GREEN (Earth wire) to the terminal block marked “ “.
An additional lighting load (maximum 1000W incandescent) may be connected to the floodlight using HO5RNF cable:
Connect the BROWN wire (Live wire) of the additional lighting load to the terminal marked “LS”.
Connect the BLUE wire (Neutral wire) of the additional lighting load to the terminal marked “N1”.
Use the second cable gland for the additional lighting load supply cable.
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
4) Remove the mounting bracket from the floodlight. Drill the wall and screw the bracket onto the wall using suitable wall
plugs and screws (FIGURE 8).
5) Re-attach the floodlight to the bracket and secure the supply cable (and
additional lighting load supply cable if applicable) to the wall using suitable
clips. Ensure that the cable is not touching the body of the floodlight, and that
there is sufficient slack in the cable to allow the floodlight to be tilted and
adjusted as required (FIGURE 9). NB: Tilt and adjust the floodlight by
grasping the metal body of the floodlight, not the wiring box.
FIGURE 8 FIGURE 9
LAMP INSTALLATION
CAUTION:
DO always handle halogen lamps with a soft clean cloth.
DO NOT touch the lamp with bare hands as this will dramatically shorten the life of the lamp.
DO NOT
touch the floodlight while it is in use or still hot. Allow it to cool before touching it.
DO NOT use a halogen lamp rated higher than 300 watts.
l
WARNING isolate the power supply before installation.
1) Use a flat blade screwdriver to open the front cover clip on the floodlight (FIGURE 10).
2) Pull down the front surround which is mounted on hinges and will swing open (FIGURE 11).
3) Install the lamp by inserting one end into the lamp holder and depressing until enough clearance is gained to seat the
other end of the lamp into the lamp holder. Rotate the halogen lamp to ensure proper seating (FIGURE 12).
4) Refit the front surround and secure with the front cover clip (FIGURE 13).
FIGURE 10
FIGURE 11
FIGURE 12
FIGURE 13
Page 2 of 4
