1
INSTRUCTIONS
WARNING: READ ENTIRE MANUAL AND COMPLY WITH ALL SAFETY AND SERVICE
PRECAUTIONS. DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY OCCUR IF
INSTRUCTIONS ARE NOT FOLLOWED CAREFULLY.
UNPACKING AND SET-UP *REFER TO PARTS LIST FIG. 1
1. Carefully unpack the lift making sure that all of the parts have been included.
2.
Remove the lift and all parts from delivery pallet and place on a clean, solid flat surface.
3.
Safely, manually lift the Deck Plate (57) so that the Safety Bar (46) sits within the first safety
latch. It is recommended at least two people perform this function.
4. XLT ONLY: Remove one of the Stabilization Pipe Caps (26) from the Stabilization Bar (27). Slide
the stabilization bar through the square tubing of the Outside Lifting Arm (28) and place the
stabilization cap back on the end. Secure the Stabilization Bar in place with the steel Ball Pins
(25).
5. If using the Front Extension (55), slide the front extension over the front of the deck plate so
that the support pipe holes align. Hold the front extension in place by connecting the Eye Bolts
(56) with a Washer Φ10 (23) and Nut M10 (24) (Optional Equipment).
6. Take the Fixed Clamp (63) and bolt it to the Deck Plate (57) or Front Extension (55) using the
provided bolts (64), Washers Φ10 (23) and Nuts M10 (24). Insert the Tire Stop (61) onto the
Fixed Clamp using the Pin (62) (Optional Equipment).
7.
Take the Crank Assembly (60) and bolt it to the Deck Plate (57) or Front Extension (55) using
the Provided Bolts (64.1), Washers Φ10 (23) and Nuts M10 (24). Bolt Moveable Clamp (84) to
Crank Assembly (60) using the provided Bolts (81) (Optional Equipment).
8. If using the Side Extensions (52), slide the Support Pipes (53) through Support Pipe holes in
the front and rear of the Deck Plate (57). Slide the Side Extensions over the Support Pipes and
secure in place with the Quick Pins (54).
9. Hook the Ramp (58) and Extension Panels (51) onto the back of the Deck Plate (57) and Side
Extensions (52).
10.
Take ends of Air Hose (2) and attach to Foot Operated Air Valve (1) and the Front Cover (6) of
the cylinder.
11.
Attach compressed air to the Foot Operated Air Valve (1) to 100 PSI air supply and raise the lift
by moving the valve to the up position. Requires 90-100PSI air supply.
WARNING:
Roller Dropout Plate (78) must be removed prior to unloading the motorcycle
from the lift & replaced with the Standard Dropout (59). Do NOT operate motorcycle on Roller
Dropout (78). Roller Dropout (78) is not to be used as a dyno device.
WARNING:
The lift may be damaged and/or personal injury may result if the
pressure
exceeds the maximum 100 PSI rating.
NOTE:
Use caution that mounting bolts for Fixed Clamp (63) do not interfere with the frame
support bar movement when using the front extension.
NOTE:
Standard Dropout Plate (59) can be removed for easy rear wheel removal. Roller
Dropout Plate (78) can be installed after motorcycle is loaded for easy rear wheel cleaning
or maintenance.
