12
description of unit / starting operation
Impact 440
3.5
TechNIcAl DATA
voltage
220~240 VAC, 50/60 Hz
max. current consumption
4.5 A
power cord
See page 84
max. operating pressure
221 bar (22.1 MPa)
volume flow at 12 mpa (120 bar) with water
2.0 l/min
max tip size
0.023 inch – 0.58 mm
max. temperature of the coating material
43°C
max viscosity
20.000 MPa·s
Weight
17.9 kg
Special high-pressure hose
DN 6 mm, 15 m, connection thread M 16
x 1.5
Dimensions (l x W x h)
437 x 363 x 416 mm
Altitude
This equipment will operate correctly up
to 2000 m above mean sea level
vibration
Spray gun does not exceed 2.5m/s
2
max sound pressure level
80 dB*
* Place of measurement: 1 m distance from unit and
1.60m above floor, 12 MPa (120 bar) operating pressure,
reverberant floor
3.6
TrANSporTATIoN IN vehIcle
Secure the unit with a suitable fastening.
4
STArTINg operATIoN
4.1
hIgh-preSSure hoSe, SprAy guN AND
SepArATINg oIl
1. Screw the pressure gauge (1) to the coating material
outlet (Fig. 2, Item 2).
2. Screw the high-pressure hose (3) to the coating material
outlet (Fig. 2, Item 4).
3. Screw the spray gun (5) with the selected tip onto the
high-pressure hose.
4. Tighten the union nuts at the high-pressure hoses firmly
so that coating material does not leak.
2
3
5
1
4
5. Remove the oil cup cap with a straight-slot screwdriver.
6. Fill the oil cup with Piston Lube (Fig. 3). Do not use too
much Piston Lube, i.e. ensure that no Piston Lube drips
into the coating material container.
Attention
Piston Lube prevents increased wear and tear to
the packings.
7. Replace oil cup cap.
8. Press oil button 2-5 times to prime the oiler. Press once for
every eight hours of usage to lubricate the fluid section.
9. Fully depress the pusher stem to make sure the inlet ball is
free.
