Titan DK 3700C, Руководство оператора

Страница: 26 / 46

MICHEL VAN DE WIELE NV
Instruction Manual TITAN DK3700C
4. UPPER AND LOWER TRANSPORT
It is important to have the right pressure on the transport wheels.
To much pressure will cause an abnormal wearing of the transport wheels.
If the pressure is too low, the carpet won’t be transported correctly or slipping can
occur.
To change the pressure
:
To change the pressure on the transport wheels Fig10 :
1. Turn the screw A in Fig A CLOCKWISE to INCREASE the pressure
2. Turn the screw A in Fig A COUNTER-CLOCKWISE to DECREASE the pressure
on these wheels.
5. DRIVING BELT
When the machine leaves the factory, all parts are perfectly synchronised. If the belt
is wearing out, the synchronisation between the upper and lower transport
mechanism will be lost. If this is the case the belt should be replaced as follows :
1. Remove the needle from the machine.
2. Unscrew 3 x E (see Fig 11 ) and remove the wheel B
3. Unscrew 2 x F and remove the belt protection lid A
4. Both screws C and D must be loosened by one turn (two screws in each,
indicated under C and D)
5. Both gears can then be pulled from their axis while the old belt still remains in its
place.
6. To fit the new belt, both gears should be placed into the belt and fitted at the same
time on both axis.
7. In order to set the machine, the lower gear must be fixed with the 2 screws D.
8. Screws C which are still loose enable to move the upper gear with regard to the
axis until a correct setting is obtained according to Fig 2 page..
9. Fix the screws C and reassemble the parts in the opposite sequence as described
in the beginning of this paragraph. (Step 3 then 2 then 1).
- 9 –