10
6.
Once the rubber saddles have been positioned under the vehicle lifting points, operate the
power switch to make contact and lift the vehicle slightly. Test to make sure the vehicle
is well balanced and the contact between the rubber saddles and vehicle lifting points are
secure by performing the “BUMPER TEST.” (pg. 2) Then, proceed to lift the vehicle to the
desired height.
7.
WARNING:
Do not lift the vehicle if you cannot establish secure and level
lifting points. Do not use sub-standard shims or other devices in place of approved and
recommended rubber saddle adapters. Never use the lift without the rubber saddles in
place on each plate and in contact with the lifting points of a vehicle.
8.
Press up button and raise vehicle to desired height. Do not go under vehicle until load
rests on level safety locks.
9.
While lifting the vehicle a clicking sound should be noticeable which indicates the safety
mechanism is operating. If this sound is not heard, immediately cease using the lift and
call an authorized service agent.
10. When lift reaches maximum height, a limit switch will come into operation and stop the
lift. When lift has stopped, press and hold the lowering handle (Fig. 3) until load rests on
safety locks.
11.
Once the repair work to the vehicle is complete, make sure to remove all tools, safety jack
stands, and materials from under the vehicle and lift. Also, make sure the work area is
clear and it is safe to lower the vehicle.
12.
Lower vehicle by pressing the Up button to disengage the safety locks. Squeeze the
lock-release handle (Fig. 4), and then press the lowering handle (Fig. 3) until the lift is
completely lowered.
13.
Move the rubber saddles and plates inward, out of the path of the vehicle. Clear all
bystanders, and any objects from work area and direction of vehicle.
14.
Disengage the vehicle parking brake. Start the vehicle’s engine, and drive the vehicle off
the lift slowly and carefully.
WARNING: THE OPERATOR MUST BE TRAINED AND AUTHORIZED TO
OPERATE THE LIFT.
WARNING: DO NOT GO UNDER VEHICLE UNDER ANY CIRCUMSTANCES
WHILE VEHICLE IS BEING RAISED OR LOWERED.
WARNING: LOAD MUST BE EVENLY DISTRIBUTED BETWEEN BOTH LIFTING
PLATFORMS. IF LOAD IS UNBALANCED, REPOSITION VEHICLE. DO NOT LOWER
ON TO LOCKS AT DIFFERENT HEIGHTS.
