5
Step 5 – Secure HARROW DRAG TUBE onto Chain Assembly
- Insert
HARROW DRAG TUBE (11)
through
four Clevis hooks
of
SHORT CHAIN (18)
at the front end of
DRAWBAR MAIN FRAME (20)
, and
four Clevis hooks
of
SHORT CHAIN (18)
at the rear end of
REAR DRAG BAR (9)
.
- Insert
LYNCH PIN (10)
at both ends of each
HARROW DRAG TUBE (11)
as stopper for sliding out.
Step 6 – Put on Long Chain
- Secure
two
LONG CHAIN (6)
onto
DRAWBAR MAIN FRAME (20)
at the front end.
- Fasten
CHAIN CLAMP (7)
onto left and right sides of
REAR DRAG BAR (9)
using
U BOLT (19)
,
FLAT WASHER M10 (1)
,
SPRING WASHER M10 (21)
and
HEXA NUT M10 (22
), and secure
the
LONG CHAIN (6)
onto left and right sides of
REAR DRAG BAR (9)
.
Step 7
– Put on tractor 3pt Pins
- Insert
CAT1 TOP PIN (5)
onto the upper pin bracket of
DRAWBAR MAIN FRAME (20)
, and secure the pin
with
COTTER PIN 4x70 (4).
- Insert
CAT2 TOP PIN (17)
onto the upper pin bracket of
DRAWBAR MAIN FRAME (20)
, and secure the pin
with
LYNCH PIN (10)
.
- Insert
two
CAT1/2 STEP PIN (16)
onto lower pin tabs of
DRAWBAR MAIN FRAME (20)
, and secure the pin
with
LYNCH PIN (10)
.
Step 8 – Tighten all hardware after hooking up drag harrow at proper hook up positions.
