Titan Attachments 177CBUCKET, Руководство пользователя

Страница: 6 / 18

6
TO OPERATE THE IMPLEMENT
1. Turn on the skid steer
2. Properly adjust the direction and angle of the bucket for loading.
a. The bucket should be set on the ground.
b. The bucket’s bottom should be parallel with the ground.
3. Load the concrete material into the bucket.
a. Make sure to gradually add water to the mixture during the loading phase.
b. Do not overfill the bucket. A good marker for a fully loaded bucket is an
approximately 2” auger blade showing outside of the concrete mixture.
4. Once the material is fully loaded, the implement should be lifted from the ground.
5. After lifting the implement, the auger should be turned on and the RPMs of the
auger should be increased to no more than 50% of maximum speed.
TO UNLOAD THE BUCKET
1. The user may use the side discharge chute.
a. To use the side discharge chute, the discharge chute must be hooked onto
the implement near the bearing block.
2. The auger must also be put in reverse to expel the material.
a. When the discharge chute is in place, the handle must be pulled to open
the chute and release the material.