Tisira TDW12AX, Руководство пользователя, Страница: 17 / 32

Dishwasher User Manual Page 17
To start a cycle wash:
1. Draw out the lower and upper basket,
load the dishes, and push the baskets
back in.
2. Pour in the detergent as instructed
3. Partially close the door and press the
power button. Press the program button,
and the program will proceed in the
following order:
ECO 90min Rapid Soak
4. Once a program has been selected, the
corresponding program indicator light will
display. Press the Start/Pause button and
the dishwasher will commence washing.
Have you forgotten to place a dish
in the dishwasher?
1. Press the Start/Pause button to pause
the washing program.
2. Open the door slightly.
WARNING // Take particular care when
opening the door during a washing program
because the hot water may scald.
NOTE // The appliance will pause, the display
will stop flashing and the buzzer will sound
every minute until the door is closed.
3. After the spray arms have stopped, the
door can be completely opened
4. Add the forgotten dishes
5. Close the door, and press the start/pause
button. The dishwasher will resume
functioning after 10 seconds.
Changing a running program
A cycle that is underway can only be changed
to a different program if it has only been
running for a short period of time. Otherwise,
the detergent may have already been released
and the appliance may have already drained
the washing water.
If this is the case, the detergent dispenser
must be refilled (See Section “Filling the
detergent dispenser “- Page 14)
To change a running program:
1. Press the Start/Pause button, and the
dishwasher will enter into standby mode.
2. Press the program button for a few seconds
to cancel the current program in use.
3. Change the program to your desired
cycle setting (See Section “Washing Cycle
Table – Page 16)
4. Close the door, and press the start/pause
button to begin the new program.
At the end of the wash
When the washing cycle has finished, the
buzzer will sound for 8 seconds, then stop.
The program light will remain on (it won’t
flash) to indicate that the program has ended.
Switch off the dishwasher by pressing the
power button, and leave the dishwasher door
slightly opened.
Operating Instructions