6
INSTALLATION MANUAL
Model: TIS-Health-CM
TIS CONTROL LIMITED
RM 1502-p9 Easey CommBldg
253-261 Hennessy Rd Wanchai
Hong Kong
TEXAS INTELLIGENT SYSTEM LLC
SUITE# 610. 860 NORTH DOROTHY DR
RICHARDSON
TX 75081.USA
Copyright © 2020 TIS, All Rights Reserved
TIS Logo is a Registered Trademark of Texas Intelligent System LLC in the
United States of America. This company takes TIS Control Ltd. in other
countries. All of the Specifications are subject to change without notice.
w w w . t i s c o n t r o l . c o m
ENERGY SERVANT 10 FUNCTIONS CONTROLLER
TROUBLESHOOTING
The sensor’s LED blinks rapidly.
Reason:
The sensor address conflicts with
another device in the TIS network. You need
to press and hold on the sensor PCB PRG
button for 6 seconds so that the sensor can
get a new address.
The sensor’s LEDs do not
turn ON, and the device is not
powered.
Reason:
The TIS 24V power supply is not
connected to the TIS-BUS.
The sensor fails to control the
device channels.
Reason 1:
The TIS-BUS connection has a
problem, or the wire has a short.
Reason 2:
The programming address is
faulty.
The sensor LED is always off,
but it works fine.
Reason:
LED is disabled in the software.
The sensor’s sensitivity is not
strong.
Reason 1:
The sensitivity level is reduced in
the software.
Reason 2:
The ceiling where the sensor is
installed is not high enough.
