BALLAST CONTROLLER MODULE
INSTALLATION MANUAL
MODEL: RLY-6CH-0-10V
TIS CONTROL LIMITED
RM 1502-p9 Easey CommBldg
253-261 Hennessy Rd Wanchai
Hong Kong
TEXAS INTELLIGENT SYSTEM LLC
SUITE# 610. 860 NORTH DOROTHY DR
RICHARDSON
TX 75081.USA
Copyright © 2020 TIS, All Rights Reserved
TIS Logo is a Registered Trademark of Texas Intelligent System LLC in the
United States of America. This company takes TIS Control Ltd. in other
countries. All of the Specifications are subject to change without notice.
w w w . t i s c o n t r o l . c o m
6 Channels 0-10V
TROUBLESHOOTING
PRG Button Blinks Red Color
Rapidly
Reason:
The Module address conflicts with
other device in TIS network, you need to
press and hold the PRG button for 6 seconds
so the module can get new address
Device PRG LED is not Blinking;
Device not Powered
Reason:
Device is not powered on; no TIS-
BUS 24V supply connected to the device.
Device Button LED ON but
lights not ON
Reason 1:
Lights’ neutral wire not connected
Reason 2:
Channel protection delay time is
enabled in software.
Wall Panels can’t Pair with the
Device
Reason 1:
TIS-BUS connection has a
problem; check the wires and make sure
there’s not a short in the connection.
Reason 2:
Manual programming function
disabled in the device (default is enabled).
Wall Panels can’t Control the
Device Channels
Reason 1:
TIS-BUS connection has a
problem; check the wires and make sure
there’s not a short in the connection.
Reason 2:
Programming address is wrong.
