Lubrication
Use an airline lubricator with the oil set at two (2) drops per minute.
If an airline lubricator cannot be used then once a day add 1 to 2 drops special (SAE 10) air
motor oil into the air inlet.
Maintenance
Disassemble and inspect air motor and governor assembly every three months if the
tool is used every day. We prefer that you use our distributor to replace damaged or
worn parts.
Please use the spare parts list as a guide manual when dismantling or assembling the
tool.
High wear parts are indicted as service kit in the parts list. To reduce risk of injury,
everyone using, installing, repairing, maintaining, changing accessories on, or working
near this tool must read and understand these instructions before performing any such
task.
Pneumatic Sander and Polisher safety instructions
The goal is to offer tools that help you work safely and efficiently.
The most important safety device for this or any tool is YOURSELF.
Your care and good judgement are the best protection against injury. All possible hazards
cannot be covered here, but we have tried to highlight some of the important ones. This tool
and its accessories must not be modified.
This tool may only be use by qualified people.
For additional safety information consult:
The instruction manual and any leaflet packed with this tool.
Your employer, union and/or trade association.
Council of the European communities and/or local codes.
“ Safety requirements for hand-held non-electric Power Tools “. Available from:
European committee for standardization, Rue de Stassart 36, 1050 BRUSSELS,
BELGIUM.
Air supply and connection hazards:
Air under pressure can cause severe injury.
Always shut off air supply, drain hose of air pressure and disconnect tool from air supply,
when not in use, before changing accessories or when making repairs.
Put never direct air at yourself or anyone else.
Whipping hoses can cause serious injury. Always check for damaged or loose hoses
and fittings.
Do not exceed maximum air pressure of 6.2 bar or as stated on the name plate.
Do not use quick disconnect couplings at tool. See instructions for correct set-up.
Entanglement dangers:
Keep away from moving sanding pad.
Do not wear jeweled or loose clothing and avoid long hair.
Choking can happen if neckwear is not kept away from tool and accessories.
Scalping can happen if hair is not kept away from tool and accessories.
Avoid direct contact with accessories during and after use. Gloves will reduce the risk of
cuts or burns.
