ee--m
maaiill::
vvooiiccee::
360.854.9559
ffaaxx::
866.783.1742
11
WRC-4 Web Based Remote Control
INSTALLATION
Alert Setup Dialog
The Alert Setup dialog specifies which alerts will be issued and the conditions that cause alerts.
Alerts are sent to all registered SNMP trap recipients and all registered e-mail alert recipients.
Low Threshold
Sets the low analog threshold. If an analog value falls below this
value, an alert will be issued. NOTE: This value represents the
actual analog register value 0-1023, not the scaled value.
High Threshold
Sets the high analog threshold. If an analog value exceeds this
value an alert will be issued. NOTE: This value represents the
actual analog register value 0-1023, not the scaled value.
Active (Analog)
Activates/Deactivates the alert.
Active (Digital)
Activates/Deactivates the alert. Alerts are issued when the state of
a digital input changes.
Com Fail Threshold
Sets the communication failure threshold. The firmware keeps
track of communication failures between the on-board Web Server
and microcontroller. If the number of sequential errors reaches the
threshold, an alert is issued.
Active (Com Fail)
Activates/Deactivates the alert.
Login Fail Threshold
Sets the login failure threshold. This feature is turned OFF. The
default is set to 0. The firmware keeps track of failed login
attempts. If the number of sequential failures reaches the thresh-
old, logins are suspended and an alert is issued. This condition
may represent an attempt to breach the security of the system.
Logins are re-enabled by restarting the firmware, either through a
power-cycle reboot, or by rebooting via the Telnet setup menu at
TCP port 9999.
OK
Save the settings and exit.
Cancel
Exit without saving settings.