Timpdon Marine
Tel 0161 - 980 8054
Issue 1 – June 2011
Web
www.timpdon.co.uk
EMail [email protected]
When satisfied, press and hold both switches
S1
and
S2
together.
The
LED
will flash rapidly for about 2 seconds, and then go on
continuously. Then release both switches.
If you release either switch before the LED stops flashing, the unit
will remain in program Step 3.
The unit will then save all programmed values to non-volatile memory.
The
LED
will then flash rapidly for about 4 seconds to indicate completion
of programming, and then the
MRSS4
will automatically reboot in normal
operation mode, with the new programmed settings operational.
The
MRSS4
is now ready for use.
Notes on Programming
1
Once you have entered programming mode, there is no exit until all
programming steps have been completed. If you enter programming mode
inadvertently, and you do not wish to re -program the unit, remove and re -
apply power, to restart in normal operation mode.
2
Remember that no new programmed settings are saved until the end of
programming
Step 3
. All steps must therefore be completed for
programming to be valid.
3
If you make an error during programming, simply repeat the programming
procedure after the unit has re -booted in normal operation mode.
