Device Wiring (Without Secure Door Control Unit)
Notes:
When connecting door magnetic sensor and exit button, the device and the
RS-485 card reader should use the common ground connection.
The Wiegand terminal here is a Wiegand input terminal. You should set
the face recognition terminal’s Wiegand direction to “Input”. If you should connect
to an access controller, you should set the Wiegand direction to “Output”. For details,
see Setting Wiegand Parameters in Communication Settings in the user manual.
2
2.1
Network Interface
Installation Environment:
Indoor and outdoor installation are supported. If installing the device
indoors, the device should be at least 2 meters away from the light, and
at least 3 meters away from the window or the door. If installing the
device outdoors, you should apply Sililcone sealant among the cable
wiring area to keep the raindrop from entering.
Make sure the environment illumination is more than 100 Lux.
Direct Sunlight
Direct Sunlight
through Window
Indirect Sunlight
through Window
Dimensions:
Backlight
Note:
The figures are for reference only.
10Lux
＞1200Lux
100~850Lux
1
2
3
Notes:
The installation height here is the recommended height. You can change it according
to your actual needs.
You can also install the device on the wall or other places without the gang box. For
details, refer to the User Manual.
For easy installation, drill holes on mounting surface according to the supplied
mounting template.
Drill holes on the wall or other surface according to the mounting template and install the gang box.
Use two supplied screws (4_KA4×22-SUS
)
to secure the mounting plate on the gang box.
Use another four supplied screws to secure the mounting plate on the wall.
Route the cables through the cable hole of the mounting plate, and connect to the corresponding
external devices’ cables.
Note:
Apply Silicone sealant among the cable wiring area
to
keep the raindrop from entering.
Before you start:
According to the baseline on the mounting template, stick the mounting template on the wall or
other surface, 1.4 meters higher than the ground.
Note:
Make sure the output of external power supply fulfils LPS.
Steps:
4
5
Insert the fingerprint module to the holes at the bottom of the main part.
Align the device with the mounting plate and hang the terminal on the
mounting plate.
Make sure the two sheets on each side of the mount plate have been in the
holes at the back of the device.
Use two supplied screws (SC-M4×12TP10-SUS) to secure the device and the
mounting plate.
Apply
Sililcone
sealant
3m
2m
1
Installation
Close to Light
1
3
2
Hole1
Hole1
Hole1
Hole1
Hole2
Hole2
Hole2
Hole2
Hole3
Recommanded Height:1.40 m.
87 mm
196.8 mm
5
5
4
Mounting Template
Datum
Camera
IR Light
White Light
Screen
Card Presenting
Area
Fingerprint
Scanner
USB Interface
Wiring
Terminal
Power
Interface
Debugging
Port
(For debugging
only)
116.5 mm
290 mm
33 mm
PSAM Card
Card Slot
(Reserved)
SIM Card Card Slot
(Reserved)
IR Light
Network
Interface
Quick Start Guide
TimeWatch
ULtraFace
Series
