5
w w w . i - t i m e t e c . c o m
PIR/Motion Sensor
1. The installation location should be chosen where the intruder is easily
accessible, avoiding the location of the equipment against the air con-
ditioning port or vents, and the mounting surface should be strong and
free from vibration.
. There should be no objects in front of the detector.
.
Double-sided adhesive installation:
With the double-sided adhesive of the box attached to the PIR/Motion
Sensor on the back, and then fixed on the wall, pay attention to keep the
sticky surface clean.
Wall mounting installation:
The user can select the horizontal (hole 1, 5), right angle (, 4, 7, 8), in-
clined suction (hole , 6) and so on according to the actual wall (Figure
). It should be careful to avoid installation in pets, air conditioning, heat
sources and other electrical objects caused by changes in temperature,
while avoiding direct sunlight.
4. Glue nail installation diagram
Remove the face shell, with a screwdriver to remove the fixed circuit
board screws (Figure , marked 9 position). Remove the circuit board; de-
termine the installation location, with the attached screws directly to the
back cover fixed to the wall. According to the “focus adjustment” instruc-
tions, according to the actual situation to adjust the location of the circuit
board, with a fixed screw circuit board to determine the correct installa-
tion of the circuit board. Finally put on the battery, close the cover.
INSTALLATION
