Micro Lynx ACG Option Card
ECC NO. 1019
Page 7
73630 REV. C
PROCEDURE (continued):
11. The Option Card cable is a ribbon cable with four connectors attached. On one end of
the cable, the second connector is about 3.5" from the end. Insert this end into
connector J1 on the component side of the ACG Card. The connector should be
attached so that the cable falls away from the ACG Card, as illustrated in Figure 3.
12. Position the ACG Card component side down with connector J1 toward the front of the
System Unit. Approximately 1.25" from the J1 connector, bend the Option Card cable
under, so that it makes a right-angle turn (the unused connectors on the cable will face the
chassis bottom).
13. Insert the folded Option Card cable through the opening in the Option Card bracket.
14. Lie the ACG Card flat on the Option Card bracket. Slide the ACG Card against the
back panel, so that the
AES/EBU
connector and the
O.S. OUT
,
WORD OUT
and
CLOCK IN
jacks are seated in the appropriate cutouts in the back panel. Insert the washers and
nuts onto the BNC connectors. Replace the mounting standoffs on the 9-pin connector.
15. The corner of the ACG Card, with the black rubber bumper, will rest on the "L"
bracket installed on the side of the chassis in Step 5. Insert two phillips screws
through the ACG Card into the Option Card bracket and tighten. (See Figure 7.)
Figure 7. Install the ACG Card
16. If the M3 Card is fitted, insert the Option Card cable connector into J1 on the M3
Card. If the VITC Card is fitted, insert the Option Card cable connector into J1 on the
VITC Card.
17. Connect the other end of the cable into J3 on the Main Board. The unused connectors
will lie in the open area in the middle of the System Unit, unless you have option cards
installed.
18. Replace the top cover and the six phillips screws.
