4
4. Installation
After choosing a suitable location install the unit as follows:
The unit is suitable for connection to a 230 V ac 50Hz electricity supply. It is
suggested that 3-core round flexible cable of 1mm² or 1.5mm² gauge is used.
An internal switch should be installed to switch the power to the unit ON & OFF.
This unit uses an integral wall fixing plate, detach the wall fixing plate by
unscrewing and release but do not remove the fixing screw on the underside of
the wall plate (Diagram 3).
Mark the position of the wall fixing holes ( 60mm ). Ensure the wall plate is
correctly positioned. Note the “UP” ident on the inside of the wall plate . Drill the
holes, insert the wall plate into the holes.
Pierce and pass the cable through the grommet before securing the
wall plate to the wall
.
It is recommended that the grommet is pierced with a screwdriver to ensure a
better seal. (Diagram 4).
Fix the wall plate to the wall with screws provided . Connect the cable to the
terminal block on the unit as follows ( Diagram 5 ):
Neutral (Blue )
N
EARTH (Green/ Yellow)
LIVE (Brown)
L
Ensure Connections are secure.
Ensure any extra cable and the tether is tucked into the space in the wiring box.
The unit is supplied with a hanging attachment (tether) to aid installation. Ensure
the tether is securely fixed into the slot before releasing the weight of the unit.
(Diagram 6)
IMPORTANT
Switch off the electricity at the fuse box by removing the relevant
fuse or switching off the circuit breaker before proceeding with
the installation (Diagram 2).
