Timberwolf TW SX200, Руководство пользователя

Страница: 14 / 57

TIMBERWOLF
TW SX200
13
IT IS ESSENTIAL TO CARRY OUT THE FOLLOWING TESTS to check safety equipment - this sequence
of tests will only take a few seconds to carry out. We recommend that these tests are carried out daily -
checking the control boxes on both sides of the funnel . Observing the function as described will
confirm that the safety circuits are working correctly. This is also a good opportunity to remind all
operators of the control and emergency stop systems.
BEFORE USING THE SHREDDER - PETROL MODELS
OPERATING INSTRUCTIONS
STARTING THE ENGINE - PETROL MODELS
FOR A COLD ENGINE:
Place the throttle control at 1/3 throttle and pull the choke out.
Insert ignition key into starter switch.
Turn the key to start the engine. Release the key as soon as
the engine starts.
Gradually return the choke to the off position as the engine starts
and warms up. Allow the engine to warm up for at least one
minute before shredding.
FOR A WARM ENGINE:
Follow the instructions for a ‘cold engine’ but return the choke to
the off position as soon as the engine starts.
If engine fails to start after 10 seconds leave for 1 minute and try again.
Do not continuously crank engine.
STARTER
SWITCH
THROTTLE
LEVER
CHOKE
3
1
2
PRESS THE GREEN
BUTTON
THE IN-FEED
SHOULD TURN FORWARDS
PRESS THE RED
SAFETY BAR
THE IN-FEED
SHOULD STOP
PRESS THE BLUE BUTTON
THE IN-FEED SHOULD TURN
BACKWARDS ONLY WHILE THE
BUTTON IS PRESSED
WITH THE ENGINE RUNNING AT FULL SPEED
This label indicates the speed setting of
the shredder. With the throttle lever in
the fast position (hare) the machine is
ready to shred.
When the machine is not in use for short
periods of time move the lever to the idle
position (tortoise) or turn off completely.
FAST
SLOW
ENGINE CONTROLS -
PETROL MODELS
STOPPING THE ENGINE - PETROL MODELS
MOvE the throttle lever to the ‘Tortoise’ to reduce the engine speed to idle.
LEAvE the engine running for 1 minute.
TURN the power switch to position 0. The engine should stop after a few seconds.
REMOvE the ignition key.
For more detailed information refer to the Engine Owner’s Manual