Timberwolf TW 280FTR (Petrol), Инструкция по эксплуатации

Страница: 28 / 68

4.5 Engine Controls
On the TW 280FTR the engine controls are located on
the control panel, in the centre of the machine, forward
of the feed funnel on the left side (Figure 7).
They consist of an ignition switch, a throttle selector
switch and a Malfunction Indicator Light (MIL).
The throttle selector switch is duplicated on the driving
control panel. Both switches are spring-loaded to the
centre position and either can be used to select the
throttle setting at any time.
When the ignition is turned on, the MIL will light to show
the system is operational.
Figure 7 - Control Panel
If the MIL illuminates continuously, or flashes, while the engine is running, this
indicates an engine fault. Stop the machine immediately and seek further assistance
from a Timberwolf dealer.
4.6 Crawler Track Controls
WARNING
NEVER LEAVE THE CHIPPER ON A SLOPE UNATTENDED.
NEVER TRANSPORT PASSENGERS ON THE DRIVER'S PLATFORM.
The TW 280FTR is designed to operate in either Chipping Mode or Tracking Mode. It
cannot operate in both modes at the same time.
The Driving Control Panel (Figure 8) contains all of the
controls required to select and operate the crawler
tracks.
Figure 8 - Driving Control Panel
4.6.1 Chipping Mode
When the selector lever on the Driving Control Panel is moved to
Chipping Mode (Figure 9), hydraulic power is directed to the feed
rollers.
The cutting disc is being rotated by the rotor drive belts.
The machine is not able to be tracked.
Figure 9 - Chipping
Mode Selection
26/66 C190-0308 - Rev 1.0 EN
TW 280FTR (Petrol) 4 Operating Instructions